|
|
||||||||||||||||
CONTACT
 |
Balinese Kite
|
All
of our kites are completely assembled and usually it takes the fitting
of just one or two rods to be ready for flying.Only the latest and best
materials are selected. They have to be the best because the going can
get tough when the wind starts blowing. Our kites are built entirely by
hand, by experienced craftsmen who love to share their enthusiasm for
these flying machines.
|
Easy to bring, not need much room, just like folder.
Easy to put in like on kite assemble note
 |
Kite
Assembly note:
1. untie the string wrapped around the kite's mid-section to allow the wings to fall loose beside the body of the kite 2. From the back, slide the plastic holder down about an inch (2.5 cm). This will extend the bottom of the wings a way fromthe body. 3. to ope the wings, rotate one wing at a time over the cross bar and underthe catch (wrapped with white string), repeat for the second wing. 4. be careful the kite string meant to be in back, doest not catch in front of the kite when opening the wing. in the case of fish scales or dragon horns on your kite, maneuver the bamboo supports for each wing. Slide the plastic holder upward, bring the wing to the body and tie. |
 |
 KITE-01 DINOSAURUS SIMPLE KITE
|
 KITE-06 DRAGON KITE
|
 KITE-03 MONKEY KITE
|
||||||||||||||||||||||||||||||||||||
 DINOSAURUS ELEGANT KITE
|
 KITE-04 ELEGANT BEE KITE
|
 LITE-05 DRAGONFLY KITE
|
||||||||||||||||||||||||||||||||||||
 KITE-07 FLYING FROG KITE
|
|
 KITE-09 COX KITE
|
||||||||||||||||||||||||||||||||||||
 KITE-10 BUTERFLY KITE
|
 KITE-11 EAGLE KITE
|
|
||||||||||||||||||||||||||||||||||||
 KITE-13 FLYING BIRD KITE
|
 KITE-24 LIZARD KITE
|
 KITE-15 FISH KITE
|
||||||||||||||||||||||||||||||||||||
 KITE-16 TUTLE KITE
|
TIGER KITE
|
BOAT
KITE
|
